The PLM series filter element is made of polypropylene microfiber hot-melt entanglement, and the fibers are randomly bonded in space to form a three-dimensional microporous structure, and the outer gradient of the outer diameter is small, the pressure difference is small, and the amount of dirt is large. It can effectively remove impurities such as suspended solids, particles and rust in the fluid. It has good filtering effect and long life.
Features and benefits
The filter element has a dense and uniform pore size and high filtration efficiency.
Progressive density structure, grading retention, high dirt holding capacity
100% pure PP, high cleanliness, no pollution to water quality
Surface fiber structure is strengthened, it is not easy to produce hair removal
Pre-filtering of drinking water and RO membrane reverse osmosis, etc.
Imaging liquid, ink filtration, plating solution filtration
Industrial water filtration
Outer diameter (mm): ¢60, ¢65, ¢115 (or other outer diameter size)
Inner diameter (mm): ¢28, ¢30 (can be customized to other sizes)
Length: 5〞, 10〞, 20〞, 30〞, 40〞, 50〞, 60〞 (can be customized for other lengths)
Filter element interface: flat type, 222 type, 226 type
Outside the table shape: there are common type, groove type, embossed type, fine line type, orange peel type, big fat type
Filter material: polypropylene (PP)
End cap: polypropylene
Center rod: polypropylene
Gasket/seal: silicone rubber, ethylene propylene rubber, nitrile rubber, fluoro rubber
Filtration accuracy: 0.5μm, 1μm, 5μm, 10μm, 25μm, 50μm, 75μm, 100μm
Maximum operating temperature: 82 ° C
Maximum pressure difference: 2.0Bar, 21°C