Categories

Hot Products

Separator Cartridge

FiBRSep Fiberglass Filter Separator Elements

FiBRSep Fiberglass Filter Separator Elements

Sealing a Double Open End Element
A filter element is only as good as the seal that is achieved between the dirty
and clean side of the filter vessel. The difficulty of sealing the element
is primarily a function of the vessel manufacture's element support and sealing hardware.
Elements with open ends and flat gaskets are subject to
bypassing contaminant under the following conditions:
•The element appears to be bowed or sagging.
•The gasket at both ends does not contact the sealing surface with adequate pressure all the way around the gasket.
•The sealing surfaces are dirty or damaged.
Send InquiryChat Now

1.Product Introduction of the FibrSep Fiberglass Filter Separator Elements

Bottom sealing surfaces are made in two primary configurations; knife-edge and flat washer. Top sealing surfaces are also made in two primary configurations; dimpled and flat.  A  knife-edge  seal has a ridge on the vessel's bottom element seat that cuts into the gasket. A dimpled seal has a rounded ridge that pushes out against  the inside surface and down on the flat surface of the gasket. Flat surfaces fit flush against the flat surface of  the  gasket.  Knife-edge and dimpled designs are less prone to bypass.

1.Max. D.P. may be limited by vessel manufacturer’s design.

2.145 psid with high pressure core.

When installing an element ensure that all sealing surfaces are clean and undamaged. Center the element against the sealing surfaces, tighten the securing mechanism (nuts, cams, etc.) as specified by  the manufacturer. Always double check for loose elements because some elements shrink as they are tightened.

Remember the element is only as good as the seal that you achieve during installation.

2.Replacement part number of the FibrSep Fiberglass Filter Separator Elements

Model

O.D. [in.]

I.D. [in.]

Length [in.]

FG-12

3.3

2.1

12

FG-24

3.3

2.1

24

FG-36

3.3

2.1

36

FG-72

3.3

2.1

72

FG-312

4.5

3.24

12

FG-324

4.5

3.24

24

FG-336

4.5

3.24

36

FG-372

4.5

3.24

72

FG-536

5.5

4.18

36

FG-572

5.5

4.18

72

3.Production Process of the FibrSep Fiberglass Filter Separator Elements

MPI Series Flushing Pleated Paper Filter Cartridges.jpg

Hot Tags: fiBRsep fiberglass filter separator elements, China, suppliers, manufacturers, factory, customized, buy, price, quotation, pricelist, in stock, free sample, made in China
  • QR CODE
  • facebook